R&S ESU Series Operating Manual page 443

R&S ESU
6.1 Introduction
This chapter describes all remote control commands of the R&S ESU in detail. For details on the nota-
tion of the remote control commands refer to
Before sending a command sequence consisting of commands described in chapter 6, please make
sure that the analyzer mode is active, by one of the following actions:
• Set the preset compatibility to the analyzer mode (SYST:PRES:COMP FSP command).
• Perform a preset (*RST).
• Use the INST:SEL SAN command.
The remote control commands are sorted according to the subsystem they belong to. The following
subsystems are included in this chapter:
• "Common Commands" on page 6.8
• "ABORt Subsystem" on page 6.11
• "CALCulate Subsystem" on page 6.12
• "CALibration Subsystem" on page 6.98
• "DIAGnostic Subsystem" on page 6.100
• "DISPlay Subsystem" on page 6.104
• "FORMat Subsystem" on page 6.114
• "HCOPy Subsystem" on page 6.115
• "INITiate Subsystem" on page 6.125
• "INPut Subsystem" on page 6.129
• "INSTrument Subsystem" on page 6.134
• "MMEMory Subsystem" on page 6.138
• "OUTPut Subsystem" on page 6.151
• "SENSe Subsystem" on page 6.152
• "SOURce Subsystem" on page 6.220
• "STATus Subsystem" on page 6.226
• "SYSTem Subsystem" on page 6.235
• "TRACe Subsystem" on page 6.246
• "TRIGger Subsystem" on page 6.260
• "UNIT Subsystem" on page 6.262
An alphabetical list of all remote commands is provided at the end of this chapter in section
List of Remote Commands" on page
supported. These commands are listed in section
8568A/B and 8594E" on page
For information on differences between the FSP and FSE families refer to section
Behavior between the FSP and the FSE Families of Instruments" on page
6.4
"Notation" on page
6.336. Additionally, a subset of remote commands of HP models is
"GPIB Commands of HP Models 856xE, 8566A/B,
6.263.
Remote Control – Description of Commands
6.5.
6.289.
Operating Manual 1302.6163.12 - 03
Introduction
"Alphabetical
"Differences in GPIB