R&S ESU Series Operating Manual page 640

R&S ESU
[SENSe<1|2>:]POWer:ACHannel:FILTer:ALPHa:CHANnel<1...12> 0...1
This command sets the rolloff factor of the RRC weighting filter for the TX channel. It is only available
if Fast ACP is not active and no predefine standard is selected.
Example:
"POW:ACH:FILT:ALPH:CHAN 0.26"
'sets Alpha to 0.26
Characteristics: *RST value: 0.22
SCPI: device-specific
Mode: A
[SENSe<1|2>:]POWer:ACHannel:FILTer:ALPHa:ACHannel 0...1
This command sets the rolloff factor of the RRC weighting filter for the adjacent channel. It is only
available if Fast ACP is not active and no predefine standard is selected.
This command changes the setting for the alternate channels as well.
Example:
"POW:ACH:FILT:ALPH:ACH 0.26"
'sets Alpha to 0.26
Characteristics: *RST value: 0.22
SCPI: device-specific
Mode: A
[SENSe<1|2>:]POWer:ACHannel:FILTer:ALPHa:ALTernate<1...11> 0...1
This command sets the rolloff factor of the RRC weighting filter for the alternate channels. It is only
available if Fast ACP is not active and no predefine standard is selected.
This command changes the setting for the adjacent channel as well. The numeric suffixes at ALTernate
are irrelevant for this command.
Example:
"POW:ACH:FILT:ALPH:ALT 0.26"
'sets Alpha to 0.26
Characteristics: *RST value: 0.22
SCPI: device-specific
Mode: A
[SENSe<1|2>:]POWer:ACHannel:FILTer:STATe:ALL ON | OFF
This command switches the weigthing filter state for TX channel, adjacent channel and all alternate
channels on or off. It is only available if Fast ACP is not active and no predefine standard is selected.
Example:
"POW:ACH:FILT:STAT:ALL ON"
'activates weighting filters for all channels
Characteristics: *RST value: OFF
SCPI: device-specific
Mode: A
Operating Manual 1302.6163.12 - 03
Remote Control – Description of Commands
SENSe Subsystem
6.201