R&S ESU Series Operating Manual page 217

R&S ESU
3
With higher numbers the procedure is expanded accordingly.
Remote command:
This increased number of adjacent channels is realized for all the relevant settings
like:
ACLR LIMIT CHECK
EDIT ACLR LIMITS
ADJ CHAN
BANDWIDTH
ADJ CHAN SPACING :SENS:POW:ACH:SPAC:ALT1..11 4MHz
NO. OF TX The NO. OF TX CHAN softkey enables the entry of the number of carrier signals to
CHAN be considered in channel and adjacent-channel power measurements.
Numbers from 1 to 12 can be entered.
The softkey is available only for multi carrier ACP measurements.
Remote command:
CHANNEL The CHANNEL BANDWIDTH softkey opens a table for defining the channel band-
BANDWIDTH widths for the transmission channels and the adjacent channels.
The transmission-channel bandwidth is normally defined by the transmission stan-
dard. The correct bandwidth is set automatically for the selected standard (see CP/
ACP STANDARD softkey).
4.186
The channel power, the power of the upper and lower adjacent channel, the
power of the next higher and lower channel (alternate channel 1) and of the
next but one higher and lower adjacent channel (alternate channel 2) are mea-
sured.
:CALC:LIM:ACP:ACH:RES?
:CALC:LIM:ACP:ALT1..11:RES?
:CALC:LIM:ACP:ACH:STAT ON
:CALC:LIM:ACP:ACH:ABS –10dBm,-10dBm
:CALC:LIM:ACP:ACH:ABS:STAT ON
:CALC:LIM:ACP:ALT1..11 0dB,0dB
:CALC:LIM:ACP:ALT1..11:STAT ON
:CALC:LIM:ACP:ALT1..11:ABS –10dBm,-10dBm
:CALC:LIM:ACP:ALT1..11:ABS:STAT ON
:SENS:POW:ACH:BWID:ALT1..11 30kHz
SENS:POW:ACH:ACP 1
SENS:POW:ACH:TXCH:COUN 12
Operating Manual 1302.6163.12 - 03
Instrument Functions
Analyzer Mode