R&S ESU Series Operating Manual page 676

R&S ESU
Mode: R, A
SYSTem:COMMunicate:RDEVice:GENerator<1|2>:TYPE <name>
This command selects the type of external generator 1 or 2. For a list of the available generator types
including the associated interface, see chapter
section "List of Generator Types Supported by the R&S ESU" on page
Generators with TTL interface can also be operated via GPIB alone.
With NONE selected, the corresponding generator 1 or 2 is deactivated.
The command is only available with option Ext. Generator Control, R&S FSP-B10.
Example:
"SYST:COMM:RDEV:GEN2:TYPE 'SME02'"
'Selects SME02 as generator 2.
Characteristics: *RST value: NONE
SCPI: device-specific
Mode: R, A
SYSTem:COMMunicate:SERial:CONTrol:DTR IBFull | OFF
SYSTem:COMMunicate:SERial:CONTrol:RTS IBFull | OFF
These commands switch the hardware handshake procedure for the serial interface off (OFF) or on
(IBFull).
The two commands are equivalent.
Example:
"SYST:COMM:SER:CONT:DTR OFF"
"SYST:COMM:SER:CONT:RTS IBF"
Characteristics: *RST value: -- (no influence on this parameter, factory default OFF)
SCPI: conform
Mode: R, A
SYSTem:COMMunicate:SERial[:RECeive]:BAUD 110 | 300 | 600 | 1200 | 2400 | 9600 | 19200 | 38400
| 57600 | 115200 | 128000
This command sets the transmission speed for the serial interface (COM).
Example:
"SYST:COMM:SER:BAUD 2400"
Characteristics: *RST value: -- (no influence on this parameter, factory default 9600)
SCPI: conform
Mode: R, A
SYSTem:COMMunicate:SERial[:RECeive]:BITS 7 | 8
This command defines the number of data bits per data word for the serial interface (COM).
Example:
"SYST:COMM:SER:BITS 7"
Characteristics: *RST value: -- (no influence on this parameter, factory default 8)
SCPI: conform
Mode: R, A
Operating Manual 1302.6163.12 - 03
Remote Control – Description of Commands
"External Generator Control – Option R&S
SYSTem Subsystem
FSP-B10",
4.347.
6.237