Selection And Setting Of Traces - Trace Key - R&S ESU Series Operating Manual

R&S ESU
Order of signals detected:
PEAK:
NEXT PEAK:
NEXT PEAK:
or
PEAK:
NEXT PEAK LEFT:
NEXT PEAK RIGHT: Signal 2
NEXT PEAK RIGHT: Signal 2 (no further signal detected)
With 6 dB peak excursion, all signals will be detected with NEXT PEAK and NEXT
PEAK RIGHT / NEXT PEAK LEFT.
Order of signals detected:
PEAK:
NEXT PEAK:
NEXT PEAK:
NEXT PEAK:
or
PEAK:
NEXT PEAK LEFT:
NEXT PEAK RIGHT: Signal 1
NEXT PEAK RIGHT: Signal 2
NEXT PEAK RIGHT. Signal 4
AUTO MAX The AUTO MAX PEAK / AUTO MIN PEAK softkeys add an automatic peak search
PEAK | action for marker 1 at the end of each particular sweep.
AUTO MIN
For further information refer to the descriptions in section
PEAK
MAX PEAK AUTO MIN PEAK" on page
4.6.5 Selection and Setting of Traces – TRACE Key
The R&S ESU is capable of displaying up to three different traces at a time in a dia-
gram. A trace consists of a maximum of 625 pixels on the horizontal axis. If more
measured values than pixels are available, several measured values are combined
in one pixel.
The traces are selected using the SELECT TRACE softkey in the menu of the
TRACE key.
The traces can individually be activated for a measurement or frozen after comple-
tion of a measurement. Traces that are not activated are blanked.
The display mode can be selected for each trace. Traces can be overwritten in each
measurement (CLEAR/WRITE mode), averaged over several measurements
(AVERAGE mode), or a maximum or minimum value can be determined from sev-
eral measurements and displayed (MAX HOLD or MIN HOLD mode).
In IF analysis mode only the sample detector for the traces is available.
4.90
Signal 1
Signal 2
Signal 2 (no further signal detected)
Signal 1
Signal 1 (no further signal detected)
Signal 1
Signal 2
Signal 3
Signal 4
Signal 1
Signal 3
4.168.
Instrument Functions
IF Spectrum Analysis Mode
"Analyzer Mode"
Operating Manual 1302.6163.12 - 03
– "AUTO