R&S ESU Series Operating Manual page 607

R&S ESU
[SENSe<1|2>:]DETector<1..3>:RECeiver[:FUNCtion] POSitive | NEGative | RMS | AVERage |
QPEak | CAVerage | CRMS
In receiver mode, this command switches on the detectors for an individual measurement to record
measured values.
The trace cannot be selected; three detectors can be switched on simultaneously.
Example:
"DET:REC POS,AVER,QPE"
'Switches on the peak, average and quasipeak detectors.
Characteristics: *RST value: AVER
SCPI: device-specific
Mode: R
[SENSe<1|2>:]DETector<1..3>:FMEasurement NEGative | POSitive | RMS | AVERage | QPEak |
CAVerage | CRMS
This command selects the detector for the final measurement which is performed subsequent to the
overview measurement.
Example:
"DET:FME POS"
Characteristics: *RST value: Trace 1 QPEak
Trace 2 AVERage
Trace 3 RMS
SCPI: device-specific
Mode: R
6.168
Remote Control – Description of Commands
Operating Manual 1302.6163.12 - 03
SENSe Subsystem