5Entry Of Scan Data - R&S ESU Series Operating Manual

R&S ESU
4.5.5.5 Entry of Scan Data
SWEEP Pressing the SWEEP key opens the menu to configure and start the scan.
TDOMAIN SCAN |
STEPPED SCAN
USE CURR
SETTINGS
FIXED
FREQUENCY
SINGLE SCAN
CONTINUOUS
SCAN
FREQ AXIS
LIN | LOG
RUN PRE-
SCAN+FINAL
RUN SCAN
A scan is defined in the form of tables or it is performed using the current setting.
In the SCAN table, the scan subranges are defined. Each scan range is specified by
start frequency, stop frequency, step width and the measurement parameters that
are valid for this range.
The scan can be performed as a single scan or continuously (softkeys SINGLE
SCAN and CONTINUOUS SCAN).
Scanning is started with the RUN SCAN softkey.
Operating Manual 1302.6163.12 - 03
ADJUST AXIS
!
INS BEFORE
RANGE
INS AFTER RANGE
DELETE RANGE
RANGES 1-5 | 6-10
FREQ AXIS
LIN | LOG
10dB MIN ON | OFF
RUN PRE-
SCAN+FINAL
RUN SCAN
HOLD SCAN
STOP SCAN
Instrument Functions
HOLD SCAN CONT AT REC
FREQ
CONT AT HOLD
STOP SCAN
STOP SCAN
CONT AT REC
FREQ
CONT AT HOLD
STOP SCAN
Receiver Mode
4.55