R&S ESU Series Operating Manual page 489

R&S ESU
CALCulate<1|2>:MARKer<1...4>:MINimum:RIGHt
This command positions the specified marker to the next higher minimum value to the right of the
current value (i.e. in ascending X direction) on the corresponding trace.
If no next higher minimum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: -200) is produced.
Example:
"CALC:MARK2:MIN:RIGH"
'Positions marker 2 in screen A to the next higher minimum value to the right of the
current value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
This command is an event and therefore has no *RST value and no query.
CALCulate<1|2>:MARKer<1...4>:MINimum:LEFT
This command positions the specified marker to the next higher minimum value to the left of the current
value (i.e. in descending X direction) on the corresponding trace.
If no next higher minimum value is found on the trace (level spacing to adjacent
values < peak excursion), an execution error (error code: -200) is produced.
Example:
"CALC:MARK2:MIN:LEFT"
'Positions marker 2 in screen A to the next higher minimum value to the left of the
current value.
Characteristics: *RST value: -
SCPI: device-specific
Mode: R, A
This command is an event and therefore has no *RST value and no query.
CALCulate<1|2>:MARKer<1...4>:PEXCursion <numeric_value>
This command defines the peak excursion, i.e. the spacing below a trace maximum which must be
attained before a new maximum is recognized, or the spacing above a trace minimum which must be
attained before a new minimum is recognized. The set value is valid for all markers and delta markers.
The unit depends on the selected operating mode.
Example:
"CALC:MARK:PEXC 10dB"
'Defines peak excursion 10 dB.
Characteristics: *RST value: 6dB
SCPI: device-specific
Mode: R, A
The numeric suffix in MARKer<1...4> is irrelevant.
6.50
Remote Control – Description of Commands
CALCulate Subsystem
Operating Manual 1302.6163.12 - 03