R&S ESU Series Operating Manual page 58

R&S ESU
RUN PRE-
SCAN+FINAL
RUN SCAN
Side menu
RECEIVER
FREQUENCY
ADD TO PEAK LIST
CONTINUOUS
BARGRAPH
SINGLE
BARGRAPH
RECEIVER The RECEIVER FREQUENCY softkey activates the entry field of the receiver fre-
FREQUENCY quency.
The tuning frequency has to be set to at least twice the IF bandwidth.
When the tuning frequency is lower than twice the IF bandwidth, the IF bandwidth is
automatically reduced so that this condition is met again.
If the frequency is increased again, the original IF bandwidth is restored (memory
function). The memory is cleared when the IF bandwidth is manually changed.
Range: 20 Hz ≤ f
This softkey is also available in the RECEIVER/FREQ menu.
Remote command:
ADD TO
The ADD TO PEAK LIST softkey adds the receiver frequency to the peak list (see
PEAK LIST also section
Remote command:
CONTINUOUS
The CONTINUOUS BARGRAPH softkey selects the continuous measurement
BARGRAPH
mode.
Remote command:
SINGLE Pressing the SINGLE BARGRAPH softkey triggers a single level measurement. The
BARGRAPH
enhancement label SGL displayed at the screen edge indicates that the single-mea-
surement mode is set.
Remote command:
Operating Manual 1302.6163.12 - 03
ESH2-Z5 | ESH3-
Z5 | ENV 4200 | ENV
216 | OFF
PRESCAN
PHASES | FINAL
!
PHASES
RUN FINAL MEAS
≤ f
rec max
FREQ:CENT 300 MHz
4.5.4.4"Data Reduction and Peak List" on page
--
INIT:CONT ON
INIT:CONT OFF
Instrument Functions
PHASE N | PHASE
L1 | PHASE L2 |
PHASE L3
150 KHZ HIGHPASS
PE GROUNDED |
PE FLOATING
4.33).
Receiver Mode
4.27