Toyota Tundra 2005 Service - Repair - Maintenance page 1826

New O−Ring
Seal Packing
Front
LH Side
ENGINE MECHANICAL (2UZ−FE)
(c)
(d)
A04855
15.
(a)
P12477
(b)
HINT:
After applying the specified torque, rotate the drain union clock-
wise until its drain port is facing forward.
16.
Port
17.
18.
19.
A04856
20.
21.
22.
Install the mounting bracket with the 4 bolts. Install the 2 mount-
ing brackets.
23.
(a)
(b)
24.
Install the bracket with the bolt.
25.
26.
27.
A08472
− CYLINDER BLOCK
Install a new O−ring to the cylinder block.
Install the oil seal retainer with the 7 bolts.
Torque: 8.0 N·m (80 kgf·cm, 71 in.·lbf)
INSTALL ENGINE COOLANT DRAIN UNIONS
Apply seal packing to 2 or 3 threads.
Seal packing: Part No. 08826−00100 or equivalent
Install the 2 drain unions.
Torque: 49 N·m (500 kgf·cm, 36 ft·lbf)
INSTALL OIL PUMP (See page LU−15)
INSTALL OIL STRAINER (See page LU−15)
INSTALL NO.1 OIL PAN (See page LU−15)
INSTALL OIL PAN BAFFLE PLATE
(See page LU−15)
INSTALL NO.2 OIL PAN (See page LU−15)
INSTALL WATER PUMP (See page CO−8)
INSTALL ENGINE MOUNTING BRACKETS
Torque: 36 N·m (370 kgf·cm, 27 ft·lbf)
INSTALL ENGINE WIRE TO LH SIDE OF CYLINDER
BLOCK
Install the brackets on the engine wire with the 2 bolts.
Install the engine wire cover with the 2 bolts.
INSTALL OIL COOLER PIPE BRACKET FOR A/T
INSTALL VVT SENSORS (See page SF−79)
INSTALL KNOCK SENSORS (See page SF−70)
INSTALL STARTER (See page ST−19)
EM−123