Toyota Camry Manual page 2138

Length = 240 mm (9.45 in.)
Join
Line
SST
ENGINE MECHANICAL (1MZ–FE)
14.
(a)
If the gasket has cracks or peeling, etc., replace it using these
steps:
Join
Line
NOTICE:
When joining 2 gaskets, do not leave a gap between them.
Cut off any excess gasket.
Length = 460 mm
(18.11 in.)
(b)
P12982
15.
(a)
(b)
A04693
16.
Install the generator bracket with the pivot bolt and nut. Do not
tighten the bolt yet.
P18816
17.
18.
19.
20.
21.
– TIMING BELT
INSTALL NO.1 TIMING BELT COVER
Check that the timing belt cover gaskets have cracks or
peeling, etc.
Using a screwdriver and gasket scraper, remove all
the old gasket material.
Thoroughly clean all components to remove all the
loose material.
Remove the backing paper from a new gasket and
install the gasket evenly to the part of the timing belt
cover shaded black in the illustration.
After installing the gasket, press down on it so that
the adhesive firmly sticks to the timing belt cover.
Install the timing belt cover with the 4 bolts.
Torque: 8.5 N·m (85 kgf·cm, 74 in.·lbf)
INSTALL CRANKSHAFT PULLEY
Align the pulley set key with the key groove of the pulley,
and slide on the pulley.
Using SST, install the pulley bolt.
SST 09213–54015 (91651–60855), 09330–00021
Torque: 215 N·m (2,200 kgf·cm, 159 ft·lbf)
INSTALL NO.2 GENERATOR BRACKET
Torque: (Nut): 28 N·m (290 kgf·cm, 21 ft·lbf)
INSTALL NO.2 RH ENGINE MOUNTING BRACKET,
ENGINE MOVING CONTROL ROD, NO.2 RH ENGINE
MOUNTING STAY (M/T) AND RH ENGINE MOUNTING
STAY (See page EM–76)
CONNECT GROUND STRAP CONNECTORS
CONNECT ENGINE COOLANT RESERVOIR HOSE TO
WATER OUTLET
INSTALL PS PUMP DRIVE BELT
INSTALL GENERATOR DRIVE BELT
(See page CH–16)
Author :
EM–25
Date :
1311