Toyota Camry Manual page 1681

DI–654
3 Check airbag sensor assembly.
Spiral
Cable
D Squib
D+
D–
DLC1
E1 Tc
AB0069
H01002
AB0119
AB0118
W02043
R13006
OK
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
Assembly
(c)
ON
ACC
CHECK:
(a)
or
(b)
DTC B0103/12
(c)
(d)
(e)
OK:
H01131
HINT:
Codes other than code B0103/12 may be output at this time, but
they are not relevant to this check.
NG
– SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect D+ and D– of the connector
(on the spiral cable side) between the spiral cable and the
steering wheel pad.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See step 5 on page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0103/12 is not output.
Replace airbag sensor assembly.
Author : Date :
889