Toyota Camry Manual page 2054

80 –115°
Knoc k
Pin
2 – 3 mm
(0.08 – 0.12 in.)
1
5
6
3
4
9
10
SST
ENGINE MECHANICAL (5S–FE)
(a)
HINT:
The above angle arrows the No.1 and No.3 cylinder cam lobes
of the intake camshaft to push their valve lifters evenly.
P03369
Seal
Packing
EM3373
P03370
7
8
2
P03371
P03372
– CYLINDER HEAD
Install the intake camshaft.
(1) Apply MP grease to the thrust portion of the cam-
shaft.
(2) Place the intake camshaft at 80 – 115° BTDC of
camshaft angle on the cylinder head.
(3) Apply seal packing to the No.1 bearing cap as
shown.
Seal packing: Part No. 08826–00080 or equivalent
(4) Install the bearing caps in their proper locations.
(5) Apply a light coat of engine oil on the threads and
under the heads of the bearing cap bolts.
(6) Install and uniformly tighten the 10 bearing cap
bolts in several passes, in the sequence shown.
Torque: 19 N·m (190 kgf·cm, 14 ft·lbf)
(7) Apply MP grease to a new oil seal lip.
(8) Using SST and a hammer, tap in the oil seal.
SST 09223–46011
Author :
EM–55
Date :
1227