Toyota Camry Manual page 1756

5 Check sub wire harness.
Sub Wire Harness
Squib (LH)
ON
(–)
(+)
H02280
AB0119
H02119
OK
6 Check harness between airbag sensor assembly and sub wire harness.
ON
Squib (LH)
(+)
(–)
AB0119
H02281
H02119
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
Disconnect the sub wire harness connector on the airbag sen-
sor assembly side.
Airbag
CHECK:
Sensor
(a)
Assembly
(b)
OK:
SFL+
H08267
CHECK:
Sub Wire Harness
(a)
(b)
Airbag
Sensor
Assembly
OK:
SFL+
H08256
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to ON.
For the connector (on the sub wire harness side) between
the side airbag assembly and the sub wire harness, mea-
sure the resistance between SFL+ and body ground.
Voltage: 0 V
NG Repair or replace sub wire harness.
Turn ignition switch to ON.
For the connector (on the sub wire harness side) between
the airbag sensor assembly and sub wire harness, mea-
sure the voltage between SFL and body ground.
Voltage: 0 V
NG Repair or replace harness or connector be-
tween airbag sensor assembly and sub wire
harness.
Author :
DI–729
Date :
964