Toyota Camry Manual page 2388

MX–22
MANUAL TRANSAXLE (E153)
REASSEMBLY
Reassembly is in the reverse order of disassembly.
HINT:
L
L
ADJUST OUTPUT SHAFT PRELOAD
(a)
(b)
HINT:
If necessary, tap on the case with a plastic hammer.
(c)
(d)
(e)
HINT:
When reusing the output shaft bearing, first install a shim of the
same thickness as before. If installing a new taper roller bear-
ing, first select and install a shim of lesser thickness than be-
fore.
(f)
(g)
(h)
(i)
– MANUAL TRANSAXLE ASSEMBLY
Before reassembly, select a shim by adjusting output
shaft preload.
Coat all of the sliding and rotating surfaces with gear oil
before reassembly.
Install the output shaft assembly to the transaxle case.
Install the transmission case to the transaxle case.
Install and torque the 17 bolts.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Install the output shaft rear taper roller bearing outer race.
Install the adjusting shim.
Install the rear bearing retainer.
Using a torx wrench (T45), install and torque the 7 torx
screws.
Torque: 42 N·m (430 kgf·cm, 31 ft·lbf)
Install a new lock nut to the output shaft.
Turn the output shaft right and left 2 or 3 times to allow the
bearing to settle.
Author :
MX055–01
Date :
1823