Toyota Camry Manual page 2137

EM–24
Length = 1,410 mm (55.51 in.)
ENGINE MECHANICAL (1MZ–FE)
10.
(a)
NOTICE:
Always turn the crankshaft clockwise.
P18808
(b)
If the marks do not align, remove the timing belt and reinstall it.
(c)
11.
A05052
12.
(a)
If the gasket has cracks or peeling, etc., replace it using these
steps:
(b)
(c)
P12983
13.
Install the timing belt guide, facing the cup side outward.
P18815
– TIMING BELT
CHECK VALVE TIMING
Slowly turn the crankshaft 2 revolutions, and align the tim-
ing marks of the crankshaft timing pulley and oil pump
body.
Check that the timing marks of the RH and LH timing pul-
leys with the timing marks of the No.3 timing belt cover as
shown in the illustration.
Remove the crankshaft pulley bolt.
INSTALL RH ENGINE MOUNTING BRACKET
Torque: 28 N·m (290 kgf·cm, 21 ft·lbf)
INSTALL NO.2 TIMING BELT COVER
Check that the timing belt cover gasket has no cracks or
peeling, etc.
Using a screwdriver and gasket scraper, remove all
the old gasket material.
Thoroughly clean all components to remove all the
loose material.
Remove the backing paper from a new gasket and
install the gasket evenly to the part of the timing belt
cover shaded black in the illustration.
After installing the gasket, press down on it so that
the adhesive firmly sticks to the timing belt cover.
Install the timing belt cover with the 5 bolts.
Torque: 8.5 N·m (85 kgf·cm, 74 in.·lbf)
Install the engine wire protector clamps to the No.3 timing
belt cover.
INSTALL TIMING BELT GUIDE
Author : Date :
1310