Toyota Camry Manual page 2060

SST
Clamp
(b) (c)
ENGINE MECHANICAL (5S–FE)
18.
(a)
(b)
Fulcrum
Length
HINT:
S05982
Use a torque wrench with a fulcrum length of 30 cm (1.181 in.).
19.
(a)
(b)
A07365
20.
(a)
A07363
(b)
(c)
Connector
(d)
21.
Install the intake manifold stay with the bolt and nut.
A07364
22.
(a)
(b)
(c)
(d)
(e)
(f)
(d) 23.
A01564
24.
– CYLINDER HEAD
CONNECT FUEL INLET HOSE TO DELIVERY PIPE
Temporarily connect the fuel inlet hose with 2 new gas-
kets and fuel pulsation damper.
Using SST, tighten the fuel pulsation damper.
SST 09612–24014 (09617–24011)
Torque:
34 N·m (350 kgf·cm, 25 ft·lbf)
29 N·m (300 kgf·cm, 21 ft·lbf) for use with SST
INSTALL ENGINE WIRE
Install the 2 engine wire clamps to the 2 brackets on the
front side of the intake manifold.
Install the engine wire clamp to the bracket on the LH side
of the intake manifold.
INSTALL EGR VALVE AND VACUUM MODULATOR
Install a new gasket, the EGR valve, EGR pipe and vacu-
um modulator assembly with the union nut, 2 nuts and
bolt.
Torque:
13.3 N·m (136 kgf·cm, 10 ft·lbf) for nut
61.2 N·m (624 kgf·cm, 45 ft·lbf) for union nut
Install the hose clamp to the bracket on the intake man-
ifold.
Install the VSV for the EGR with the bolt.
Connect the VSV connector for the EGR.
INSTALL INTAKE MANIFOLD STAY
Torque: 39 N·m (398 kgf·cm, 29 ft·lbf)
INSTALL WATER OUTLET
Install a new gasket and the water outlet with the 2 nuts.
Torque: 15 N·m (150 kgf·cm, 11 ft·lbf)
Connect the radiator hose to the water outlet.
Connect the water bypass pipe hose to the water outlet.
Connect the heater water hose to the water outlet.
Connect the ECT sensor connector.
Connect the ECT sender gauge connector.
CONNECT OIL PRESSURE SWITCH CONNECTOR
CONNECT NOISE FILTER CONNECTOR
Author :
EM–61
Date :
1233