Toyota Camry Manual page 1832

Unlock all doors manually
Insert key in ignition key cylinder and open driver's door
Ground terminal 9 of the wireless door lock ECU and
wait more 1 second.
Remove key from ignition key cylinder and close
driver's door within 10 seconds.
Press any button on transmitter within 10 seconds.
CONTINUED ON NEXT PAGE
DIAGNOSTICS –
(2)
(3)
(4)
(5)
4. DIAGNOSTIC PROCEDURE
Start
WIRELESS DOOR LOCK CONTROL SYSTEM
A transmitter recognition code is registered by
pressing any single button of the transmitter to be
registered. Once the code is registered, the ECU
responds again by operating once the lock and un-
lock functions of all the doors.
To register the recognition code of an additional
transmitter, follow the procedure shown in (2).
After completing the registration of the codes, re-
move the test lead from the remote control mirror
switch connector terminals to allow the system to
revert to the normal operation.
Using the registered transmitter, verify that the sys-
tem operates properly.
HINT: Diagnostic mode may be exited
at any time by ungrounding terminal 9
If not performing this operation
within 10 seconds after the
above operation, the mode will
not change into the diagnostic
mode.
If not performing this operation
within 10 seconds after the
above operation, the mode will
not change into the diagnostic
mode.
Author :
DI–805
Date :
1040