Toyota Camry Manual page 2100

ENGINE MECHANICAL (5S–FE)
If the end gap is greater than maximum, replace the piston ring.
If the end gap is greater than maximum, even with a new piston
ring, rebore all the 4 cylinders (see page EM–104) or replace
the cylinder block.
(d)
A06594
(e)
If bend is greater than maximum, replace the connecting rod as-
sembly.
Z00064
If twist is greater than maximum, replace the connecting rod as-
sembly.
Z00065
(f)
EM7538
– CYLINDER BLOCK
Inspect the piston pin fit.
At 60°C (140°F), you should be able to push the piston
pin into the piston pin hole with your thumb.
Using a rod aligner and feeler gauge, check the connect-
ing rod alignment.
(1) Check for bend.
Maximum bend:
0.05 mm (0.0020 in.) per 100 mm (3.94 in.)
(2) Check for twist
Maximum twist:
0.15 mm (0.0059 in.) per 100 mm (3.94 in.)
Inspect the piston pin oil clearance.
(1) Using a caliper gauge, measure the inside diameter
of the connecting rod bushing.
Bushing inside diameter:
22.005 – 22.017 mm (0.8663 – 0.8668 in.)
Author :
EM–101
Date :
1273