Toyota Camry Manual page 2109

Hide thumbs Also See for Camry:

Table of Contents

(Protrusion)

ENGINE MECHANICAL (5S–FE)

If any one of the cap nuts does not meet the torque specifica-

tion, replace the connecting rod bolt and cap nut as a set.

CYLINDER BLOCK

INSTALL PISTON AND CONNECTING ROD AS-

Cover the connecting rod bolts with a short piece of hose

to protect the crankshaft from damage.

Using a piston ring compressor, push the correctly num-

bered piston and connecting rod assemblies into each

cylinder with the front mark of the piston facing forward.

PLACE CONNECTING ROD CAP ON CONNECTING

Match the numbered connecting rod cap with the con-

necting rod.

Install the connecting rod cap with the front mark facing

INSTALL CONNECTING ROD CAP NUTS

The cap nuts are tightened in 2 progressive steps (steps

(b) and (d)).

If any one of the connecting rod bolts is broken or de-

formed, replace it.

Apply a light coat of engine oil on the threads and under

the nuts of the connecting rod cap.

Install and alternately tighten the 2 cap nuts in several

Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)

Show Quick Links

Table of Contents