Toyota Camry Manual page 1722

4 Check side squib (RH).
Airbag
Squib (RH)
Sensor
Assembly
ACC ON
or
DLC1
E1 Tc
H01021
AB0119
AB0118
H01068
R13006
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
DTC B0113/42
(c)
(d)
(e)
OK:
H01176
HINT:
Codes other than code B0113/42 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to LOCK.
Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
Connect the side airbag assembly (RH) connector.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See step 5 on page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0113/42 is not output.
NG Replace side airbag assembly (RH).
Author :
DI–695
Date :
930