Toyota Camry Manual page 2360

MANUAL TRANSAXLE (S51)
DISASSEMBLY
SST
1. Vehicle Speed Sensor Drive Gear Side:
REMOVE SIDE BEARING FROM DIFFERENTIAL
CASE
(a) Using SST, remove the bearing from the drive gear side
of the case.
SST
(b) Remove the vehicle speed sensor drive gear.
2. REMOVE RING GEAR
Q08148
(a) Place matchmarks on the ring gear and case.
(b) Remove the 8 bolts.
(c) Using a copper hammer, tap on the ring gear to remove
it from the case.
3. Ring Gear Side:
REMOVE SIDE BEARING FROM DIFFERENTIAL
CASE
Using SST, remove the bearing from the ring gear side of the
case.
SST
SST
Q04969
4. INSPECT SIDE GEAR BACKLASH
Using a dial indicator, measure the backlash of one side gear
while holding one pinion toward the case.
Standard backlash:
0.05 – 0.20 mm (0.0020 – 0.0079 in.)
If the backlash is not within the specification, install the correct
thrust washer to the side gears.
5. DISASSEMBLE DIFFERENTIAL CASE
(a) Using a pin punch and hammer, drive out the straight pin.
AT2799
(b) Remove the pinion shaft from the case.
(c) Remove the 2 pinions and side gears with the 4 thrust
washers from each gear.
– DIFFERENTIAL CASE
09950–00020, 09950–00030
09950–00020, 09950–00030
Author :
MX–37
MX04T–01
Date :
1887