Toyota Camry Manual page 1718

4 Check side squib (RH).
Airbag
Sensor
Squib (RH)
Assembly
DLC1
Tc
E1
H02274
AB0118 AB0119
R13006 H01067
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
ACC ON
(a)
or
(b)
DTC B0112/41 (c)
(d)
(e)
OK:
H03253
HINT:
Codes other than code B0112/41 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to LOCK.
Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
Connect the side airbag assembly (RH) connector.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See step 5 on page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0112/41 is not output.
NG Replace side airbag assembly (RH).
Author :
DI–691
Date :
926