Toyota Camry Manual page 1749

DI–722
5 Check sub wire harness.
Squib (LH)
Sub Wire Harness
(–)
(+)
H02280
H02118
OK
6 Check harness between airbag sensor assembly and sub wire harness.
Squib (LH)
Sub Wire Harness
(–) (+)
H02281
H02118
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
Disconnect the sub wire harness connector on the airbag sen-
sor assembly side.
Airbag
CHECK:
Sensor
For the connector (on the sub wire harness side) between the
Assembly
side airbag assembly and the sub wire harness, measure the
resistance between SFL+ and body ground.
OK:
SFL+
H03271
CHECK:
For the connector (on the sub wire harness side) between the
airbag sensor assembly and sub wire harness, measure the re-
Airbag
sistance between SFL+ and body ground.
Sensor
OK:
Assembly
SFL+
H08255
– SUPPLEMENTAL RESTRAINT SYSTEM
Resistance: 1 MΩ or Higher
NG Repair or replace sub wire harness.
Resistance: 1 MΩ or Higher
NG Repair or replace harness or connector be-
tween airbag sensor assembly and sub wire
harness.
Author : Date :
957