Toyota Camry Manual page 1768

3 Check airbag sensor assembly.
Airbag
P/T Squib (RH)
Sensor
Assembly
PR+ PR–
DLC1
E1
Tc
H01020
H02139
AB0118 AB0119
R13006 H01081
OK
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
ACC ON
CHECK:
(a)
or
(b)
DTC B0133/62
(c)
(d)
(e)
H02210
OK:
HINT:
Codes other than code B0133/62 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect PR+ and PR– of the con-
nector (on the seat belt pretensioner side) between the
seat belt pretensioner (RH) and the airbag sensor assem-
bly.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON and wait at least for 20
seconds.
Clear DTC stored in memory.
(See step 5 on page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0133/62 is not output.
NG Replace airbag sensor assembly.
Author :
DI–741
Date :
976