Toyota Camry Manual page 2078

A/T
Connector
ENGINE MECHANICAL (5S–FE)
A/T:
Install the 4 bolts.
24.
25.
S04616
26.
(a)
(b)
(c)
S05246
27.
(a)
(b)
(c)
28.
S05250
29.
30.
31.
(a)
(b)
(c)
(d)
32.
S05253
(a)
– ENGINE UNIT
Torque: 64 N·m (650 kgf·cm, 47 ft·lbf)
REMOVE ENGINE SLING DEVICE
CONNECT TRANSAXLE CONTROL CABLE(S) TO
TRANSAXLE
INSTALL PS PUMP
Install the PS pump with the 2 bolts.
Torque: 43 N·m (440 kgf·cm, 32 ft·lbf)
Install the drive belt.
Connect the PS oil pressure switch connector.
INSTALL A/C COMPRESSOR
Install the cylinder block insulator and A/C compressor
with the 3 bolts.
Torque: 25.5 N·m (260 kgf·cm, 19 ft·lbf)
Install the drive belt.
Connect the A/C compressor connector.
M/T:
INSTALL CLUTCH RELEASE CYLINDER AND TUBE
TO TRANSAXLE
M/T:
INSTALL STARTER (See page ST–19)
INSTALL DRIVE SHAFTS (See page SA–24)
CONNECT ENGINE WIRE TO CABIN
Push in the engine wire through the cowl panel. Install the
grommet.
Connect the 3 engine ECM connectors.
Connect the 3 cowl wire connectors to the connectors on
the bracket.
Install the under cover.
CONNECT CONNECTORS, WIRES, CABLES,
CLAMPS AND HOSES
Connect the generator wire.
Author :
EM–79
Date :
1251