Toyota Camry Manual page 2600

SF–8
Fuel Hose
Clamp
Ohmmeter
Battery
SFI (1MZ–FE)
(p)
(q)
CAUTION:
Perform connecting operations of the fuel tube connector
(quick type) after observing the precautions.
(See page SF–1)
S05351
(r)
(s)
(t)
(u)
3.
4.
5.
S06086
6.
Using an ohmmeter, measure the resistance between terminals
4 and 5.
5
4
If the resistance is not as specified, replace the fuel pump.
S04508
7.
Connect the positive (+) lead from the battery to terminal 4 of
the connector, and the negative (–) lead to terminal 5. Check
5
4
that the fuel pump operates.
NOTICE:
D
D
S04509
D
– FUEL PUMP
After checking fuel pressure, disconnect the negative (–)
terminal cable from the battery and carefully remove the
SST and fuel tube connector to prevent gasoline from
splashing.
SST 09268–41047, 09268–41250, 09268–45012
Reconnect the No.1 fuel pipe (fuel tube connector).
Surely install the fuel hose clamp to the fuel filter with
"click" sound.
After installing the clamp, check that the clamp is fixed by
pulling up the clamp.
Reconnect the negative (–) terminal cable to the battery.
Check for fuel leaks.
REMOVE REAR SEAT CUSHION
REMOVE FLOOR SERVICE HOLE COVER
DISCONNECT FUEL PUMP & SENDER GAUGE
CONNECTOR
INSPECT FUEL PUMP RESISTANCE
Resistance: 0.2 – 3.0 Ω at 20°C (68°F)
INSPECT FUEL PUMP OPERATION
These tests must be done quickly (within 10 seconds)
to prevent the coil burning out.
Keep the fuel pump as far away from the battery as
possible.
Always do the switching at the battery side.
Author : Date :
1507