DI–850
INSPECTION PROCEDURE
HINT:
The flow chart below is based on the premise that the taillights light up normally whenever the light control
switch is operated. If taillight operation is not normal when the light control switch is operated, proceed to
troubleshooting on page BE–2.
1
Check voltage between terminal TAIL of theft deterrent ECU connector and body
ground.
TAIL
OK
Check and replace theft deterrent ECU.
DIAGNOSTICS
–
THEFT DETERRENT SYSTEM
PREPARATION:
Disconnect the theft deterrent ECU connector.
CHECK:
Measure voltage between terminal TAIL of theft deterrent ECU
connector and body ground.
OK:
Voltage: 10 – 14 V
I01925
NG
Check and repair harness and connector be-
tween theft deterrent ECU and taillight control
relay (See page IN–31).
Author :
Date :
1085