Toyota Camry Manual page 1929

DI–902
INSPECTION PROCEDURE
1 Check operation of overdrive.
PREPARATION:
Test drive after engine warms up.
CHECK:
Check that overdrive ON
OK
2 Check voltage between terminal OD of harness side connector of cruise control
ECU and body ground.
ON
(–) (+)
AB0119
I00143
OK
DIAGNOSTICS
OFF occurs by operation of OD switch ON–OFF.
PREPARATION:
(a)
(b)
O/D
(c)
CHECK:
Measure voltage between terminal OD of harness side connec-
tor of ECU and body ground.
OK:
I00174
– CRUISE CONTROL SYSTEM
NG Check and repair electronically controlled
transmission (See page DI–389).
Remove the ECU with connector still connected.
Turn ignition switch ON.
Disconnect the ECU connector.
Voltage: 10 – 14 V
NG Go to step 5.
Author : Date :
1137