Toyota Camry Manual page 1991

EC–10
Air Inlet Port
Air Drain Port
Air Inlet Port
Vacuum
Air Inlet Port
Vacuum
EMISSION CONTROL (1MZ–FE)
Purge Port
EVAP
Air
Port
B01150
Purge Port
B01151
Purge Port
If operation is not as specified, replace the charcoal canister.
10.
EVAP
11.
Port
12.
B01152
13.
– EVAPORATIVE EMISSION (EVAP) CONTROL SYSTEM
(3) While holding the purge port and the air drain port
closed, blow air (1.76 kPa, 18 gf/cm
the EVAP port and check that air does not flow from
the air inlet port.
(4) Apply vacuum (3.43 kPa, 25.7 mmHg, 1.01 in.Hg)
to the purge port, check that the vacuum does not
decrease when the air inlet port is closed, and
check that the vacuum decreases when the air inlet
port is released.
(5) While holding the air inlet port closed, apply vacuum
(3.43 kPa, 25.7 mmHg, 1.01 in.Hg) to the EVAP port
and check that air flows into the purge port.
(6) Remove the cap from the vent port.
INSPECT VSV FOR EVAP (See page SF–58)
INSPECT VSV FOR VAPOR PRESSURE SENSOR
(See page SF–62)
INSPECT VAPOR PRESSURE SENSOR
(See page SF–65)
REINSTALL CHARCOAL CANISTER ASSEMBLY
Author :
2
, 0.26 psi) into
Date :
1425