Toyota Camry Manual page 1825

DI–798
3 Check voltage between terminal Tc of DLC1 and body ground.
ON
ACC
or
(–)
AB0118 AB0119
R14304
NG
4 Check airbag sensor assembly.
LOCK
Airbag Sensor Assembly
AB0117 AB0118 AB0119
H01302
NG
Replace airbag sensor assembly.
DIAGNOSTICS
CHECK:
Measure the voltage between terminal Tc of DLC1 and body
Tc
ground.
OK:
(+)
H00031
PREPARATION:
ON
ACC
(a)
(b)
or
(c)
(d)
(e)
(f)
(g)
Tc
(h)
CHECK:
H01303
Check operation of SRS warning light.
OK:
NOTICE:
Pay due attention to the terminal connecting position to
avoid a malfunction.
– SUPPLEMENTAL RESTRAINT SYSTEM
Voltage: 10 – 14 V
OK Check harness between terminal E1 of DLC1
and body ground.
Turn ignition switch to LOCK.
Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
Disconnect the airbag sensor assembly connector.
Insert service wire into terminal Tc from back side as
shown in the illustration.
Connect the airbag sensor assembly connector with ser-
vice wire.
Connect negative (–) terminal cable to the battery.
Turn ignition switch to ACC or ON and wait at least for 20
seconds.
Connect service wire of terminal Tc to body ground.
SRS waning light comes on.
OK Check harness between the airbag sensor as-
sembly and DLC1.
Author : Date :
1033