Toyota Camry Manual page 2091

Hide thumbs Also See for Camry:

Table of Contents

ENGINE MECHANICAL (5S–FE)

Do not turn the crankshaft.

If the oil clearance is greater than maximum, replace the bear-

ings. If necessary, grind or replace the crankshaft.

If using a standard bearing, replace it with one having the same

number marked on the connecting rod cap. There are 3 sizes

of standard bearings, marked "1", "2" and "3" accordingly.

CYLINDER BLOCK

Lay a strip of Plastigage across the crank pin.

Install the connecting rod cap.(See page EM–107)

Remove the connecting rod cap.

(See steps (b) and (c))

Measure the Plastigage at its widest point.

Standard oil clearance:

0.024 – 0.055 mm (0.0009 – 0.0022 in.)

0.023 – 0.069 mm (0.0009 – 0.0027 in.)

Maximum oil clearance: 0.08 mm (0.0031 in.)

Standard sized bearing center wall thickness:

1.484 – 1.488 mm (0.0584 – 0.0586 in.)

1.488 – 1.492 mm (0.0586 – 0.0587 in.)

1.492 – 1.496 mm (0.0587 – 0.0589 in.)

Completely remove the Plastigage.

Show Quick Links

Table of Contents