Toyota Camry Manual page 1683

DI–656
5 Check spiral cable.
Spiral
Cable
D Squib
(–) (+)
H01000
AB0119
R14288
OK
6 Check harness between airbag sensor assembly and spiral cable.
ON
Spiral
Cable
D Squib
(–) (+)
AB0119
H01004
R14288
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
Assembly
CHECK:
(a)
(b)
ON
D+
OK:
H01133
NG
CHECK:
(a)
(b)
Airbag
Sensor
Assembly
OK:
D+
NG
H08261
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to LOCK.
Disconnect the connector between the airbag sensor as-
sembly and the spiral cable.
Turn ignition switch to ON.
For the connector (on the spiral cable side) between the
spiral cable and the steering wheel pad, measure the volt-
age between D+ and body ground.
Voltage: 0 V
Repair or replace spiral cable.
Turn ignition switch to ON.
For the connector (on the spiral cable side) between the
spiral cable and airbag sensor assembly, measure the
voltage between D+ and body ground.
Voltage: 0 V
Repair or replace harness between airbag sen-
sor assembly and spiral cable.
Author : Date :
891