Toyota Camry Manual page 2361

MX–38
SST
MANUAL TRANSAXLE (S51)
6.
(a)
SST
Q08145
(b)
(c)
SST
SM0286
7.
(a)
(b)
(c)
SM0155
8.
(a)
(b)
(c)
Z00442
(d)
(e)
SST
(f)
(g)
MT0634
– DIFFERENTIAL CASE
Transaxle Case Side:
IF NECESSARY, REPLACE DIFFERENTIAL SIDE
BEARING RETAINER OIL SEAL
Using SST and a hammer, drive out the oil seal from the
retainer.
SST 09950–60020 (09951–00680), 09950–70010
(09951–07150)
Using SST and a hammer, drive in a new oil seal until its
surface is flush with the case surface.
SST 09350–32014 (09351–32130, 09351–32150)
Coat the lip of the oil seal with MP grease.
Transmission Case Side:
IF NECESSARY, REPLACE SIDE OIL SEAL
Using a screwdriver and hammer, drive out the oil seal.
Using SST and a hammer, drive in a new oil seal until its
surface is flush with the case surface.
SST 09350–32014 (09351–32130, 09351–32150)
Coat the lip of the oil seal with MP grease.
Transaxle Case Side:
IF NECESSARY, REPLACE SIDE BEARING OUTER
RACE
Using a brass bar and hammer, drive out the bearing out-
er race.
Install the bearing retainer without an O–ring.
Install and torque the 6 bolts.
Torque: 18 N·m (185 kgf·cm, 13 ft·lbf)
Place the thinnest shim into the case.
Using SST and a press, install a new bearing outer race.
SST 09950–60020 (09951–00680), 09950–70010
(09951–07150)
Remove the 6 bolts.
Remove the bearing retainer and shim.
Author : Date :
1888