Toyota Camry Manual page 2550

SF–24
Connect
California
SFI (5S–FE)
SST
(Wire)
P01077
Except California
Z09211
S05522
– INJECTOR
(k) If you have no TOYOTA hand–held tester, connect the
positive (+) and negative (–) leads from the battery to the
fuel pump connector. (See page SF–6)
(l) Connect SST (wire) to the injector and battery for 15 se-
conds, and measure the injection volume with a gra-
duated cylinder. Test each injector 2 or 3 times.
SST 09842–30070
Volume: 51 – 63 cm
Difference between each injector:
3
12 cm (0.7 cu in.) or less
If the injection volume is not as specified, replace the injector.
2. INSPECT LEAKAGE
(a) In the condition above, disconnect the tester probes of
SST (wire) from the battery and check the fuel leakage
from the injector.
SST 09842–30070
Fuel drop: 1 drop or less per 3 minutes
(b) Turn the ignition switch OFF.
(c) Disconnect the negative (–) terminal cable from the bat-
tery.
(d) Remove the SST.
SST 09268–41047, 09842–30070
(e) Disconnect the TOYOTA hand–held tester from the
DLC3.
(f) Reconnect the fuel inlet hose to the fuel filter outlet with
2 new gaskets and the union bolt.
Torque: 29 N·m (300 kgf·cm, 22 ft·lbf)
Author :
3
(3.2 – 3.8 cu in.) per 15 seconds
Date :
1457