Toyota Camry Manual page 2085

EM–86
1
3
2
ENGINE MECHANICAL (5S–FE)
DISASSEMBLY
1.
2.
3.
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
(j)
(k)
4.
5.
(a)
(b)
6.
Remove the 3 bolts and pump bracket.
7.
8.
9.
(a)
(b)
(c)
S06011
– CYLINDER BLOCK
INSTALL ENGINE TO ENGINE STAND FOR DIS-
ASSEMBLY
REMOVE TIMING BELT AND PULLEYS
(See page EM–17)
REMOVE CYLINDER HEAD ASSEMBLY
Remove the 3 bolts and No.3 timing belt cover.
Remove the cylinder head cover.
(1) Disconnect the PCV hose from the intake manifold.
(2) Remove the 4 nuts, 4 grommets, head cover and
gasket.
Remove the camshafts. (See page EM–33)
Disconnect the knock sensor 1 connector.
Disconnect the crankshaft position sensor connector.
Disconnect the wire clamp from the generator drive belt
adjusting bar.
Disconnect the IAC valve water bypass hose from the wa-
ter bypass pipe.
Disconnect the water bypass hose (from the water by-
pass pipe) from the water outlet.
Remove the bolt holding the VSV for EGR to the intake
manifold.
Remove the 2 bolts holding the water bypass pipe to the
cylinder head.
Remove the cylinder head assembly.
(See page EM–33)
REMOVE OIL DIPSTICK
REMOVE OIL PAN AND OIL PUMP
Disconnect the crankshaft position sensor connector
from the generator drive belt adjusting bar.
Remove the oil pan and oil pump. (See page LU–7)
REMOVE PS PUMP BRACKET
REMOVE KNOCK SENSOR 1 (See page SF–57)
REMOVE OIL FILTER (See page LU–2)
REMOVE WATER PUMP, WATER BYPASS PIPE AND
OIL COOLER (w/ OIL COOLER) ASSEMBLY
w/ Oil Cooler:
Remove the nut and union bolt, and disconnect the oil
cooler. Remove the O–ring.
Remove the bolt and generator drive belt adjusting bar.
Remove the 3 bolts in the sequence shown, remove the
water pump, water bypass pipe, oil cooler (w/ oil cooler)
assembly and O–ring.
Author :
EM0YW–01
Date :
1258