Toyota Camry Manual page 2101

EM–102
15 mm
(0.59 in.)
ENGINE MECHANICAL (5S–FE)
EM0227
If the oil clearance is greater than maximum, replace the bush-
ing. (See page EM–104) If necessary, replace the piston and
piston pin as a set.
(g)
P13428
HINT:
If the location of this area cannot be judged by visual inspection,
measure the outer diameter at the location shown in the illustra-
A02826
tion.
If the outside diameter is less than minimum, replace the con-
necting rod bolt and nut as a set.
– CYLINDER BLOCK
(2) Using a micrometer, measure the piston pin diame-
ter.
Piston pin diameter:
21.997 – 22.009 mm (0.8660 – 0.8665 in.)
(3) Subtract the piston pin diameter measurement from
the bushing inside diameter measurement.
Standard oil clearance:
0.005 – 0.011 mm (0.0002 – 0.0004 in.)
Maximum oil clearance: 0.05 mm (0.0020 in.)
Inspect the connecting rod bolts.
(1) Install the cap nut to the connecting rod bolt. Check
that the cap nut can be turned easily by hand to the
end of the thread.
(2) If the cap nut cannot be turned easily, measure the
outside diameter of the connecting rod bolt with a
vernier caliper.
Standard diameter:
7.860 – 8.000 mm (0.3094 – 0.3150 in.)
Minimum diameter: 7.60 mm (0.2992 in.)
Author : Date :
1274