Toyota Camry Manual page 2395

MANUAL TRANSAXLE (E153)
Front
Q00383
MT0790
SST
Q00183
Q00116
– INPUT SHAFT
REASSEMBLY
HINT:
Coat all of the sliding and rotating surfaces with gear oil before
reassembly.
1. INSTALL NO.2 CLUTCH HUB INTO HUB SLEEVE
(a) Install the 3 springs and shifting keys to the clutch hub.
(b) Install the hub sleeve to the clutch hub.
HINT:
Direct identification groove of the hub sleeve to front of the
transmission.
2. INSTALL NEEDLE ROLLER BEARING, 3RD GEAR,
SYNCHRONIZER RING AND NO.2 HUB SLEEVE AS-
SEMBLY TO INPUT SHAFT
(a) Apply MP grease to the needle roller bearing.
(b) Assemble the needle roller bearings into the 3rd gear.
(c) Place the synchronizer rings on the gear and align the
ring slots with the shifting keys.
(d) Using SST and a press, install the 3rd gear and No.2 hub
sleeve.
SST 09506–35010
3. INSTALL SNAP RING
(a) Select a snap ring that allows the minimum axial play.
Mark Thickness mm (in.)
H 2.30 (0.0906)
J 2.35 (0.0925)
K 2.40 (0.0945)
L 2.45 (0.0965)
(b) Using a screwdriver and hammer, tap in the snap ring.
Author :
Mark Thickness mm (in.)
M 2.50 (0.0984)
N 2.55 (0.1004)
P 2.60 (0.1024)
– –
Date :
MX–29
MX059–02
1830