Toyota Camry Manual page 2618

SF–26
California A/T
SST (Union)
O–Ring
Vinyl Tube
Except California A/T
SST (Union)
O–Ring
Vinyl Tube
SFI (1MZ–FE)
(c)
SST (Hose)
(d)
(e)
HINT:
SST
Install a suitable vinyl hose onto the injector to prevent gasoline
(Clamp)
from splashing out.
SST (Hose)
SST
(Clamp)
B01914
(f)
TOYOTA
(g)
Hand–Held Tester
NOTICE:
Do not start the engine.
(h)
(i)
S05358
(j)
– INJECTOR
Install the grommet and O–Ring to the injector.
Connect SST (union and hose) to the injector, and hold
the injector and union with SST (clamp).
SST 09268–41047
Put the injector into a graduated cylinder.
Connect a TOYOTA hand–held tester to the DLC3.
Turn the ignition switch ON and push the TOYOTA hand–
held tester main switch ON.
Select the ACTIVE TEST mode on the TOYOTA hand–
held tester.
Please refer to the TOYOTA hand–held tester operator's
manual for further details.
If you have no TOYOTA hand–held tester, connect the
positive (+) and negative (–) leads from the battery to the
fuel pump connector. (See page SF–6)
Author : Date :
1525