Toyota Camry Manual page 1673

DI–646
3 Check airbag sensor assembly.
Spiral
Cable
D Squib
D– D+
DLC1
Tc
E1
H01002 AB0069
AB0118
AB0119
R13006 W02044
OK
DIAGNOSTICS
PREPARATION:
(a)
(b)
Airbag
Sensor
Assembly
(c)
CHECK:
ON
ACC
(a)
or
(b)
(c)
DTC B0101/14
(d)
(e)
OK:
H01140
HINT:
Codes other than code B0101/14 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Connect the connector to the airbag sensor assembly.
Using a service wire, connect D+ and D– of the connector
(on the spiral cable side) between the spiral cable and the
steering wheel pad.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0101/14 is not output.
NG Replace airbag sensor assembly.
Author : Date :
881