Toyota Camry Manual page 2096

ENGINE MECHANICAL (5S–FE)
Mark 1, 2 or 3
No.1 No.2 No.3 No.4
– CYLINDER BLOCK
INSPECTION
1. CLEAN CYLINDER BLOCK
(a) Remove the gasket material.
Using a gasket scraper, remove all the gasket material
from the top surface of the cylinder block.
(b) Clean the cylinder block.
Using a soft brush and solvent, thoroughly clean the cylin-
der block.
S05970
2. INSPECT CYLINDER BLOCK
(a) Inspect for flatness.
Using a precision straight edge and feeler gauge, mea-
sure the surfaces contacting the cylinder head gasket for
warpage.
Maximum warpage: 0.05 mm (0.0020 in.)
If warpage is greater than maximum, replace the cylinder block.
Z19127
(b) Visually check the cylinder for vertical scratches.
If deep scratches are present, rebore all the 4 cylinders and re-
place all the 4 pistons. (See page EM–104) If necessary, re-
place the cylinder block.
S05987
(c) Inspect the cylinder bore diameter.
HINT:
There are 3 sizes of the standard cylinder bore diameter,
marked "1", "2" and "3" accordingly. The mark is stamped on the
top of the cylinder block.
S05569
Author : Date :
EM–97
EM08J–03
1269