Toyota Camry Manual page 1766

4 Check P/T squib (RH).
P/T Squib (RH)
Airbag
Sensor
Assembly
ACC ON
or
DLC1
E1 Tc
H01021
AB0118 AB0119
R13006 H01079
OK
From the results of the above inspection, the malfunctioning part can now be considered normal.
To make sure of this, use the simulation method to check. If the malfunctioning part can not be
detected by the simulation method, replace all SRS components including the wire harness.
DIAGNOSTICS
PREPARATION:
(a)
(b)
(c)
(d)
CHECK:
(a)
(b)
(c)
DTC B0132/61
(d)
(e)
OK:
H01208
HINT:
Codes other than code B0132/61 may be output at this time, but
they are not relevant to this check.
– SUPPLEMENTAL RESTRAINT SYSTEM
Turn ignition switch to LOCK.
Disconnect negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
Connect the seat belt pretensioner (RH) connector.
Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Clear DTC stored in memory.
(See step 5 on page DI–626)
Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
Check DTC.
(See page DI–626)
DTC B0132/61 is not output.
NG Replace seat belt pretensioner (RH).
Author :
DI–739
Date :
974