Toyota Camry Manual page 2039

EM–40
Service
Bolt
3 5 10
9
1 7
Pry
ENGINE MECHANICAL (5S–FE)
25.
(a)
NOTICE:
Be careful not to damage the camshaft.
P05613
(b)
SST
S01665
(c)
(d)
S01666
26.
(a)
8 2
(b)
(c)
6 4
NOTICE:
Cylinder head warpage or cracking could result from re-
moving bolts in incorrect order.
EM7558
(d)
HINT:
If the cylinder head is off, pry between the cylinder head and cyl-
inder block with a screwdriver.
NOTICE:
Be careful not to damage the contact surfaces of the cylin-
der head and cylinder block.
S05971
– CYLINDER HEAD
DISASSEMBLE EXHAUST CAMSHAFT
Mount the camshaft in a vise.
Using SST, turn the sub–gear clockwise, and remove the
service bolt.
SST 09960–10010 (09962–01000, 09963–00500)
Using snap ring pliers, remove the snap ring.
Remove the wave washer, camshaft sub–gear and gear
spring.
REMOVE CYLINDER HEAD
Disconnect the camshaft position sensor connector.
Remove the 2 bolts holding the water bypass pipe to the
cylinder head.
Uniformly loosen and remove the 10 cylinder head bolts
in several passes, in the sequence shown.
Lift the cylinder head from the dowels on the cylinder
block, and place the cylinder head on wooden blocks on
a bench.
Author : Date :
1212