Toyota Camry Manual page 2314

LU–18
A
A
B
LUBRICATION (1MZ–FE)
(b)
HINT:
Avoid applying an excessive amount to the surface.
B
(c)
Seal Width
4 – 5 mm
7.
8.
P12568
9.
10.
11.
(a)
(b)
(c)
12.
13.
14.
15.
16.
17.
18.
19.
20.
– OIL PUMP
Apply seal packing to the No.2 oil pan as shown in the il-
lustration.
Seal packing:
Part No. 08826–00080 or equivalent
L
Install a nozzle that has been cut to a 4 – 5 mm (0.16
– 0.20 in.) opening.
L
Parts must be assembled within 3 minutes of ap-
plication. Otherwise the material must be removed
and reapplied.
L
Immediately remove nozzle from the tube and rein-
stall cap.
Install the No.2 oil pan with the 10 bolts and 2 nuts. Uni-
formly tighten the bolts and nuts in several passes.
Torque: 8 N·m (80 kgf·cm, 69 in.·lbf)
INSTALL A/C COMPRESSOR HOUSING BRACKET
Torque: 25 N·m (250 kgf·cm, 18 ft·lbf)
INSTALL NO.3 TIMING BELT COVER
(See page EM–21)
INSTALL TIMING PULLEYS (See page EM–21)
INSTALL TIMING BELT (See page EM–21)
INSTALL ADJUSTING STRUT AND PS PUMP DRIVE
BELT
Temporarily install the adjusting strut with the bolt and the
nut.
Install the drive belt with the pivot and adjusting bolts.
Torque: 43.1 N·m (440 kgf·cm, 32 ft·lbf)
Tighten the nut.
Torque: 43.1 N·m (440 kgf·cm, 32 ft·lbf)
INSTALL A/C COMPRESSOR (See page AC–47)
INSTALL GENERATOR DRIVE BELT
(See page CH–16)
INSTALL FRONT EXHAUST PIPE BRACKET TO
NO.1 OIL PAN
Torque: 21 N·m (210 kgf·cm, 15 ft·lbf)
INSTALL FRONT EXHAUST PIPE (See page EM–76)
REMOVE RH FENDER APRON SEAL
REMOVE RH FRONT WHEEL
FILL ENGINE WITH OIL
START ENGINE AND CHECK FOR LEAKS
RECHECK ENGINE OIL LEVEL
Author : Date :
1682