Toyota Camry Manual page 2391

3rd Gear
4th Gear
SST
MANUAL TRANSAXLE (E153)
DISASSEMBLY
1.
Using a feeler gauge, measure the thrust clearance.
Q06369
2.
Using a dial indicator, measure the radial clearance between
the gear and shaft.
If the clearance exceeds the maximum, replace the gear,
Q00111
needle roller bearing or shaft.
3.
Using 2 screwdrivers and a hammer, tap out the snap ring.
4.
Using SST and a press, remove the rear bearing.
5.
6.
Using 2 screwdrivers and a hammer, tap out the snap ring.
Q05165
– INPUT SHAFT
MEASURE 3RD AND 4TH GEARS THRUST CLEAR-
ANCE
Standard clearance:
3rd gear: 0.10 – 0.35 mm (0.0039 – 0.0138 in.)
4th gear: 0.10 – 0.55 mm (0.0039 – 0.0217 in.)
Maximum clearance:
3rd gear: 0.40 mm (0.0157 in.)
4th gear: 0.60 mm (0.0236 in.)
CHECK 3RD AND 4TH GEARS RADIAL CLEARANCE
Standard clearance:
3rd gear: 0.009 – 0.053 mm (0.0004 – 0.0021 in.)
4th gear: 0.009 – 0.051 mm (0.0004 – 0.0020 in.)
Maximum clearance:
3rd and 4th gears: 0.070 mm (0.0028 in.)
REMOVE SNAP RING
REMOVE REAR BALL BEARING AND 4TH GEAR
SST 09950–00020
REMOVE NEEDLE ROLLER BEARING, SPACER AND
SYNCHRONIZER RING
REMOVE SNAP RING
Author :
MX–25
MX057–01
Date :
1826