Toyota Camry Manual page 2344

3rd Gear
4th Gear
SST
MANUAL TRANSAXLE (S51)
DISASSEMBLY
1. INSPECT 3RD AND 4TH GEARS THRUST CLEAR-
ANCE
Using a feeler gauge, measure the clearance.
Standard clearance:
3rd gear: 0.10 – 0.25 mm (0.0039 – 0.0098 in.)
4th gear: 0.20 – 0.45 mm (0.0079 – 0.0177 in.)
Maximum clearance:
3rd gear: 0.30 mm (0.0118 in.)
Q05793
4th gear: 0.50 mm (0.0197 in.)
2. INSPECT 3RD AND 4TH GEARS RADIAL CLEAR-
ANCES
Using a dial indicator, measure the radial clearance between
the gear and shaft.
Standard clearance:
0.009 – 0.053 mm (0.0004 – 0.0021 in.)
Maximum clearance:
0.070 mm (0.0028 in.)
If the clearance exceeds the maximum, replace the gear,
Z00417
needle roller bearing or shaft.
3. REMOVE SNAP RING
Using 2 screwdrivers and a hammer, tap out the snap ring.
4. REMOVE REAR BEARING, 4TH GEAR, NEEDLE
ROLLER BEARING, SPACER AND SYNCHRONIZER
RING FROM INPUT SHAFT
(a) Using SST and a press, remove the 4th gear and rear
bearing.
SST
(b) Remove the needle roller bearings, spacer and synchro-
nizer ring.
5. REMOVE SNAP RING
Q05201
Using a snap ring expander, remove the snap ring.
– INPUT SHAFT
09950–00020
Author :
MX–21
MX04K–01
Date :
1871