Toyota Camry Manual page 1778

3 Check airbag sensor assembly.
P/T Squib (LH)
PL+
PL–
DLC1
E1 Tc
H01017
H02139
AB0118 AB0119
R13006 H01084
OK
DIAGNOSTICS
Airbag
Sensor
Assembly
ACC ON
or
DTC B0137/71
H02216
– SUPPLEMENTAL RESTRAINT SYSTEM
PREPARATION:
(a) Connect the connector to the airbag sensor assembly.
(b) Using a service wire, connect PL+ and PL– of the connec-
tor (on the seat belt pretensioner side) between the seat
belt pretensioner (LH) and the airbag sensor assembly.
(c) Connect negative (–) terminal cable to the battery, and
wait at least for 2 seconds.
CHECK:
(a) Turn ignition switch to ACC or ON and wait at least for 20
seconds.
(b) Clear DTC stored in memory.
(See step 5 on page DI–626)
(c) Turn ignition switch to LOCK, and wait at least for 20 se-
conds.
(d) Turn ignition switch to ACC or ON, and wait at least for 20
seconds.
(e) Check DTC.
(See page DI–626)
OK:
DTC B0137/71 is not output.
HINT:
Codes other than code B0137/71 may be output at this time, but
they are not relevant to this check.
NG Replace airbag sensor assembly.
Author :
DI–751
Date :
986