Toyota Camry Manual page 2093

EM–94
Plastigage
1
3
7
4
8
ENGINE MECHANICAL (5S–FE)
N01000
9
5
10
6
2
P00104
N00988
– CYLINDER BLOCK
HINT:
Keep the upper bearing and upper thrust washers together with
the cylinder block.
(d) Clean each main journal and bearing.
(e) Check each main journal and bearing for pitting and
scratches.
If the journal or bearing is damaged, replace the bearings. If
necessary, grind or replace the crankshaft.
(f) Place the crankshaft on the cylinder block.
(g) Lay a strip of Plastigage across each journal.
(h) Install the main bearing caps. (See page EM–107)
NOTICE:
Do not turn the crankshaft.
(i) Remove the main bearing caps.
(See steps (a) and (b))
(j) Measure the Plastigage at its widest point.
Standard clearance:
No.3
Others
Maximum clearance: 0.08 mm (0.0031 in.)
HINT:
If replacing the cylinder block subassembly, the bearing stan-
dard clearance will be:
No.3
Others
If the oil clearance is greater than maximum, replace the bear-
ings. If necessary, grind or replace the crankshaft.
Author :
STD 0.025 – 0.044 mm (0.0010 – 0.0017 in.)
U/S 0.25 0.027 – 0.067 mm (0.0011 – 0.0026 in.)
STD 0.015 – 0.034 mm (0.0006 – 0.0013 in.)
U/S 0.25 0.019 – 0.059 mm (0.0007 – 0.0023 in.)
0.027 – 0.054 mm (0.0001 – 0.0021 in.)
0.017 – 0.044 mm (0.0007 – 0.0017 in.)
Date :
1266