Toyota Camry Manual page 2414

MX–48
MANUAL TRANSAXLE (E153)
8.
Using a plastic hammer, drive in the outer race.
9.
HINT:
Install the previously selected shim.
10.
Using a torx wrench (T45), install and torque the 7 torx screws.
11.
(a)
(b)
(c)
Q00036
If the preload is not within the specification, select an appropri-
ate adjusting shim.
HINT:
The total preload will change by about 0.1 – 0.2 N·m (1 – 2
kgf·cm, 0.9 – 1.7 in.·lbf) with each 0.05 mm change in adjusting
shim thickness.
Mark
Z00309
0
1
2
3
4
5
6
7
8
12.
Using a torx wrench (T45), remove the 7 torx screws and rear
bearing retainer.
13.
14.
(a)
(b)
15.
16.
– DIFFERENTIAL CASE
INSTALL OUTPUT SHAFT REAR TAPERED ROLLER
BEARING OUTER RACE
INSTALL SHIM (See pages MX–22)
INSTALL REAR BEARING RETAINER
Torque: 42 N·m (430 kgf·cm, 31 ft·lbf)
ADJUST DIFFERENTIAL CASE SIDE BEARING PRE-
LOAD
Install a new lock nut to the output shaft.
Turn the output shaft right and left 2 or 3 times to allow the
bearings to settle.
Using a torque wrench, measure the preload.
Preload (at starting):
New bearing (Output shaft preload plus)
0.2 – 0.3 N·m (1.8 – 3.5 kgf·cm, 1.6 – 3.0 in.·lbf)
Reused bearing (Output shaft preload plus)
0.1 – 0.2 N·m (1.1 – 2.2 kgf·cm, 1.0 – 1.9 in.·lbf)
Thickness mm (in.)
2.00 (0.0787)
2.05 (0.0807)
2.10 (0.0827)
2.15 (0.0846)
2.20 (0.0866)
2.25 (0.0886)
2.30 (0.0906)
2.35 (0.0925)
2.40 (0.0945)
REMOVE REAR BEARING RETAINER
REMOVE SHIM
REMOVE TRANSMISSION CASE
Remove the 17 bolts.
Using a plastic hammer, tap the transmission case.
REMOVE OUTPUT SHAFT ASSEMBLY
REMOVE DIFFERENTIAL CASE ASSEMBLY
Author :
Mark Thickness mm (in.)
9 2.45 (0.0965)
A 2.50 (0.0984)
B 2.55 (0.1004)
C 2.60 (0.1024)
D 2.65 (0.1043)
E 2.70 (0.1063)
F 2.75 (0.1083)
G 2.80 (0.1102)
H 2.85 (0.1122)
Date :
1849