Toyota Camry Manual page 2049

EM–50
80 – 100°C
SST
SST
Both intake and exhaust
Bushing bore diameter
mm (in.) Bushing size
10.985 – 11.012
(0.4325 – 0.4335)
11.035 – 11.062
(0.4344 – 0.4355)
Intake
38.5 mm
(1.516 in.)
ENGINE MECHANICAL (5S–FE)
P03270
P13987
P03365
Use STD
Use O/S 0.05
Exhaust
40.5 mm
(1.594 in.)
P03156
– CYLINDER HEAD
REPLACEMENT
REPLACE VALVE GUIDE BUSHINGS
(a) Gradually heat the cylinder head to 80 – 100°C (176 –
212°F).
(b) Using SST and a hammer, tap out the guide bushing.
SST 09201–10000 (09201–01060),
09950–70010 (09951–07100)
(c) Using a caliper gauge, measure the bushing bore diame-
ter of the cylinder head.
(d) Select a new guide bushing (STD or O/S 0.05).
If the bushing bore diameter of the cylinder head is greater than
11.012 mm (0.4335 in.), machine the bushing bore to the follow-
ing dimension:
11.035 – 11.062 mm (0.4344 – 0.4355 in.)
If the bushing bore diameter of the cylinder head is greater than
11.062 mm (0.4355 in.), replace the cylinder head.
HINT:
Different the bushings are used for the intake and exhaust.
(e) Gradually heat the cylinder head to 80 – 100°C (176 –
212°F).
Author :
EM08B–03
Date :
1222